Bromic Heating - BH8180012 - Replacement Part - TUBE SUSPENSION KIT FOR TUNGSTEN ELECTRIC

Suspension Pole Kit for Tungsten Electric Heaters provides the necessary suspension pole kit for hanging your Tungsten Electric Heater from a higher ceiling. The suspension pole helps provide heat directly to the gathering below, while still allowing directional control.

Allows electric heaters to be suspended from the ceiling:

36" long tubes

Conceal the electrical wiring within the tube

Matte black finish to match the standard Tungsten heaters

Assembly screws included (ceiling fasteners not provided)

Heater angle may be set to straight down, 15, or 30 degrees to direct the heat where it’s needed

Lowers a Tungsten Electric Heater 3 feet from the ceiling height to achieve the ideal height of 8 feet off the ground. Tubes can be cut if a shorter distance to the ceiling is needed. Heaters should be suspended no lower than 8 feet from the ground.

Note: Does not come with bolts to mount the pole to the ceiling as the required bolts will vary based on ceiling composition; consult your contractor or designer for the correct fasteners.